Brown Eyes With A Blue Ring

Beta 2.0 Tutorial: Uncover or unclogging spray cans (spray) Proto

Now that I have resumed what the stencils I found a nasty surprise that most of my aerosols were dead. The obvious answer was that the nozzles would be covered, but to my surprise, though perfectly clean, the aerosol not throw anything.

What will we need?

Thinner
• ( thinner ) root water or other solvent you can throw paint.
  
• A pin, hook or thin wire
  
• A cloth or burlap
  

Raising the issue

I recommend expanding the image to see clearly the problem

How to solve this problem?

• The first step is to clean the nozzles, maybe that is the whole problem. No longer required to pass the tow to solvent in the nozzle orifice and then enter the pin to clean leftover paint. You can also remove the nozzle and clean inside;
  
• already proven that the nozzles are clean pour some solvent in the tube coming out of the can. Be careful because there is very little you have to put no waste;
  
• The next step is to plug the tube with the tow so as not to leave the solvent and proceed to shake the can;
  
• Then you must let stand the tin, preferably placed a lid (not the tip) so it does not volatilize the solvent . Let stand for at least 3 minutes
  
• already has rested use the pin to clean the inside of the tube, be patient because you have to scrape carefully. Move the pin from the inside out by scraping the walls until it does not leave any paint residue;
  
• Again pour some solvent in the tube. Let stand for several minutes and plugging the tube shaken the can;
  
• This step must be done with caution as it may to this point and this uncovered the blockage. What you have to do is shake the can upside down so strong, so as to leave any residues that may be stuck in the tube;
  
• Finally used the tow to cover the tube and press to see if you can throw paint. Do not despair if it does not at first, some obstructions have more than one attempt (five in my experience).
  

Ready, after a few attempts to uncover and cans are sprayed as new, now if you go back to paint, vandalize, decorate or whatever you want with your old clogged cans.